New Mic6 Aluminum Build Plate for Creator Pro, & Replicator2
Upgrade your printer to the ultimate building surfaces and easily add new future surfaces.
Aluminum MIC-6 build plate with removable and flexible build surfaces
MIC-6 is cast plate known for its stability and consistency. It is also commonly used for precision tooling and base plates because of its dimensional stability across a wide temperature range
HighTemp Embedded samarium–cobalt magnets hold the removable steel sheet securely in place even at 110C and above
This has been designed to use common metal sheets of 6x9 or 6x10 and even other brands like Geckotek, Buildtak, and other steel based products
But if you perfer a non-ferrous surfaces like glass, it also pockets for dog clamps to enable mechanical clamping.Standard Kit includes. One Mic-6 Build plate with embedded magnets. One PEI coated steel plate. One Garolite on steel plate. Replacement heavy duty springs. 2mm allen key.
Glass Plate Upgrade for FlashForge Creator Pro, no Z Shim Required
Laboratory grade Borosilicate glass build plate.
This kit will allow you to build to the full potential of your printer and does not require shims to fix Z height.
Borosilicate Also known as Pyrex and Schott glass, this glass resists clouding and pitting and is highly chemical and heat resistant. With a low rate of thermal expansion, it stays dimensionally stable during changes in temperature.
Meets MIL-G-47033 Thickness tolerance is ±0.008"
Kit includes. 177.8 x 254 x 3.3mm" Borosilicate glass plate, Conical springs to replace stock springs, Four nylon latching corners to hold glass.
Up to date installation instructions https://goo.gl/JSasGv
Raise3D Hotend Adapter for E3D v6 components
Adapter that enables using any of the E3D v6 @1.75mm hot end components with your Raise3D N2. eg heartbreak, nozzles, and heater block/s including volcano.
Same length as original R3Dv2 assembly. (not with volcano or course)
Weight 24gr vs 30gr R3Dv2 (cold end,heat break,hot end, and nozzle only)
Keep the same R3D heatsink cooling solution if you wish.
UM2 shielded data cable
Will the extruder suddenly over extrude then go back to normal or the print head acts like it's having a seizure then returns to normal?
These are classic signs of SD card read errors, first try a new card but if the problem continues replace the EXT2 cable with this shielded cable.
If this doesn't solve your problem simple return the cable for a refund.
Borosilicate Glass Plate Kit for Monoprice Maker Ultimate and Duplicator 6
Polylac ABS Resin
If you in the Saint Petersburg, FL area and are interested in this resin for $2.25/lb send me a message here.